APPLICATION AND USE. Preparation. Use in accordance with the standard Global Yacht specifications. All surfaces to be coated should be. Interline Glass Flake Vinyl Ester. Consult your International Paint representative for the system best suited for the surfaces to be protected. International Interline is a two component, heavy duty vinyl ester coating reinforced with glass flake to increase chemical and abrasion resistance.
|Published (Last):||22 June 2005|
|PDF File Size:||17.85 Mb|
|ePub File Size:||17.35 Mb|
|Price:||Free* [*Free Regsitration Required]|
Test performance results were obtained in a controlled laboratory environment and International Paint makes no claim that the exhibited published test results, or any other tests, accurately represent results found in all field environments.
If oxidation has occurred between blasting and application of Interlinethe surface should be reblasted to the specified standard. Typical Coverage per coat 2.
International Interline is a two component, heavy inter,ine vinyl ester coating reinforced with glass flake to increase chemical and abrasion resistance. Marine Coatings Marine chemicals Marine lubricants. Technical and application data herein is for the purpose of establishing a general guideline of the coating application procedures.
If a holding primer is required, please consult International Paint for a product suitable for the area of application. Customer agrees that before placing an Order, Customer has read and understood the most up to date Product Data Sheet for the Product.
Always mix a complete unit in the proportions supplied. Use in accordance with the standard Worldwide Marine Specifications. Coverage rates quoted are approximate, you agree that coverage depends on the condition of the substrate, surface absorption, texture and application method. Customer further agrees that we have no liability for any errors jnterline omissions contained within the Product Data Sheets.
Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health and safety information. Interline A two pack, glass flake reinforced vinyl ester tank coating.
Surface defects revealed by the blast cleaning process, should be ground, filled, or treated in the appropriate manner. The question has been correctly sent. Typical Coverage per coat. Frequency of cleaning will depend upon amount sprayed, temperature, relative humidity and elapsed time, including any delays.
When used in non-marine applications, different overcoating intervals apply – refer to the International Protective Coatings Interline datasheet. The figures stated above are approximate. Consult your International Paint representative interlline the system best suited for the surfaces to be protected.
Application Guidelines – Marine – AkzoNobel
Proper ventilation and protective measures must be provided during application and drying to keep solvent vapour concentrations within safe limits and to protect against toxic or oxygen deficient hazards. Overcoating information is given for guidance only and is subject to regional variation depending upon local climate and environmental conditions.
Subject to iterline thereafter.
Fresh water wash to remove all dirt and contamination. It is your responsibility to read the Product Data Sheets available below before you place an order and prior to application of the product.
International Interline 955
If oxidation has occurred between blasting and application of Interlinethe surface should be reblasted to the specified visual standard. Products Marine Coatings Marine chemicals Marine lubricants. If you do not fully understand these warnings interilne instructions or if you can not strictly comply with them, do not use this product. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning.
This product must NOT be thinned as the use of thinners may severely inhibit the curing mechanism inerline the coating. Consult your local International Paint representative for specific recommendations. A surface profile of microns is recommended.
All surfaces to be coated should be clean, dry and free interlie contamination. Application by brush is recommended for small areas only. It is good working practice to periodically flush out spray equipment during the course of the working day.
Multiple coats may be required to achieve specified film thickness. These may be subject to variation depending on factors such as differences in colour and normal manufacturing tolerances.
A two pack, glass flake reinforced vinyl ester tank coating. Read and follow all precautionary notices inherline the Material Safety Data Sheet and container labels.